Audi Q3 8U Rear Wheel Arch Fender Trim Strip Moulding Left N/S Amalfi White Y9K

Visual condition of the part

The product shows signs of use visible in the photos.

Audi Q3 8U Rear Wheel Arch Fender Trim Strip Moulding Left N/S Amalfi White Y9K is an original body component from the Protective and decorative strips group, designed for installation on the rear left side of the vehicle. It provides an aesthetic finish to the wheel arch edge and additional protection for the fender against mechanical damage and dirt, while maintaining the factory body line of the Audi.

Specifications and technical data

• SKU: 8U0853817A-AWH
• Mark: Audi
• Condition: Used
• OEM Part Number: 8U0853817A
• Substitutable numbers: 8U0853817A, 8U0 853 817 A
• Location on the vehicle: Rear, Left
• Color: Amalfi White - Y9K
• Category: Body Mouldings & Trims

Purpose and function of the component

The presented wheel arch trim is designed specifically for the rear left body section of the Audi Q3 8U generation. As a fender guard, it is responsible for:

• protecting the wheel arch edge against stone chips and minor impacts,
• stable closure of the body line in the rear wheel area,
• reducing the accumulation of dirt at the fender edge.

Thanks to its factory profile, the trim works with the original mounting points on the body, which facilitates proper alignment with other body panels.

Color and visual fit

The component is finished in Amalfi White - Y9K, a color characteristic of the Audi paint palette. Using the original shade allows for maintaining visual consistency across the entire side of the vehicle without the need for additional color matching during installation. This is particularly important for post-accident repairs and when replacing individual body parts, where color consistency with the existing paint is crucial.

Installation characteristics

The wheel arch trim is intended for installation in a specific location on the body – on the rear left side of the vehicle. The design of the component is prepared to work with factory mounting points, which enables:

• precise positioning relative to the fender and bumper,
• maintaining even gaps between adjacent panels,
• reducing stress at the contact point with the bodywork.

Such a fit promotes the maintenance of tightness and proper aerodynamics in the wheel arch area, and also facilitates potential service disassembly.

Condition and service application

The component comes from the secondary market, which makes it a cost-effective solution for maintenance and post-accident repairs, where the priority is combining original geometry with a reasonable cost. This type of trim will work well both as a replacement for a damaged fender guard and during the reconstruction of the entire wheel arch zone after bodywork and paint repairs.

Body configuration extension

Replacing the wheel arch trim with an original component allows for restoring the consistent appearance of the side body section, which is important not only for aesthetics but also for the future resale of the vehicle. Maintaining the factory layout of strips and guards influences the perception of the car as well-maintained and properly serviced.

If you are planning a comprehensive repair or upgrade of the wheel arch and fender zone in your Audi and need other components from the same group, such as covers, overlays, or additional strips, check the available parts in the Audi protective and decorative strips category.

For drivers considering broader mechanical or body repairs on secondary market vehicles, a practical guide on purchasing used components may be helpful – more information can be found in the article How to buy a used car engine and not get scammed – a step-by-step guide.