VW Volkswagen Crafter SY Accelerator Pedal Throttle Gas Pedal 2N2723503A

VW Volkswagen Crafter SY Accelerator Pedal Throttle Gas Pedal is an original component from the Pedals, pedal pads and footrests group, designed for precise control of the electronic throttle in Crafter SY generation models. This used OEM component ensures correct signal characteristics, stable powertrain operation, and compatibility with the vehicle's factory electrical installation.

Specifications and technical data

• SKU: RHD-2N2723503A
• Mark: Volkswagen
• Condition: Used
• OEM Part Number: 2N2723503A
• Substitutable numbers: 2N2723503A, 2N2 723 503 A, 6PV 010 621-53, 6PV01062153
• Part type: Accelerator Pedal
• Category: Pedal Assemblies, Pads & Parts

Purpose and technical function

The accelerator pedal for the Volkswagen Crafter SY operates in a "drive-by-wire" system, which means electronic throttle control without a mechanical throttle cable. The integrated pedal position sensor generates a signal transmitted to the engine control unit, which regulates fuel and air dosage based on this input.

Properly selected pedal operating characteristics are crucial for:

• smooth acceleration and predictable throttle response,
• maintaining stable engine RPM within the operating range,
• correct operation of driver assistance systems that rely on the accelerator pedal signal.

Advantages of using an original Volkswagen pedal

The original Volkswagen gas pedal is factory-matched to the parameters of the engine control unit and the electrical system of the Crafter SY. As a result:

• signal compatibility with ECU software requirements is maintained,
• the risk of diagnostic errors related to incorrect pedal position readings is reduced,
• installation is straightforward, without the need for wiring or mounting modifications.

A used OEM component is a cost-effective solution that simultaneously ensures factory fitment and predictable powertrain behavior.

Condition, installation and service aspects

The presented accelerator pedal is a used item, sourced from vehicle dismantling, which allows for economical vehicle repair while maintaining the manufacturer's original specifications. Before installation, a standard service procedure is recommended, including checking the connectors, proper seating in the mounting point, and potential adaptation in the engine control unit, if required by the specific equipment variant.

In practice, installation is usually limited to:

• removing the old pedal from the bracket in the driver's footwell,
• connecting the factory electrical wiring plug,
• bolting the new component into the original position, in accordance with the vehicle manufacturer's recommendations.

Integration with the vehicle control system

The gas pedal in the Crafter SY works directly with the electronic engine control unit, which is why it is essential to use a component compatible with the Volkswagen platform. Consistency with the control system translates into correct throttle response, proper cruise control operation (if equipped), and stable performance under various load conditions – which is particularly important in commercial vehicles such as the Crafter.

Offer expansion and additional information

If you are planning a comprehensive repair or upgrade of the driver's foot control area in your Volkswagen and need other components from the same group, such as additional pedals, pads, or footrests, check the available parts in the Volkswagen Pedals, pedal pads and footrests category.

If you are also considering improving cabin ergonomics and comfort on the road, it is worth considering replacing the seats with solutions from higher equipment versions – you can find more on this topic in the article Interior transformation: how branded seats from dismantling improve comfort and vehicle value.